Influence of the cathode shape on the removal rate during the EDM treatment of dielectrics
DOI:
https://doi.org/10.52304/.v23i3.268Keywords:
cavitation, pulse discharge, bubbles, electrolytes, conical and cylindrical cathodes, material removal rate (MRR), electrical discharge machining (EDM)Abstract
The increase in material removal rates and the quality of electrical discharge machining expands the possibilities of full-scale application of dielectric in industry. However, in the existing works, the dependence of the removal rate on the shape of the cathode end is insufficiently disclosed, which is carried out in an improved installation adapted for the electroerosion of dielectrics. It was found that the rate of material removal at using the conical end of the cathode is 3 times higher than on the cylindrical one, and this is a consequence of "directed" cavitation and the imposition of ultrasonic and pulse discharges on it. This article proposes a better shape for the cathode end, providing an increased rate of removal of dielectrics without changing any physical parameters of the discharge.