Production of Ti-6Al-4V microparticles by electrolyte discharges

Authors

  • Б.А. Гоипов Институт ионно-плазменных и лазерных технологий АН РУз
  • С.А. Тулаганов Институт ионно-плазменных и лазерных технологий АН РУз
  • А.А. Зарипов Институт ионно-плазменных и лазерных технологий АН РУз

DOI:

https://doi.org/10.52304/.v27i4.619

Keywords:

discharges in electrolites, IGBT-based generator, Ti-6Al-4V powder, particle size distribution, microparticle morphology

Abstract

The study aims to address the problem of producing low-cost and high-quality metallic powder
from Ti-6Al-4V alloy with morphological characteristics and particle size distribution that
meet the requirements of additive manufacturing technologies, without the need for additional
processing. As a solution, an electrical discharge machining (EDM) device based on IGBT and
FET transistors was utilized. The resulting Ti-6Al-4V powder particles were analyzed using a
laser particle size analyzer and ImageJ software. According to the analysis results 77.1% of the
particles fall within the 10–40 μm range with a narrow particle size distribution, and the sphericity
coefficient is 0.867, indicating an ellipsoidal or spherical particle shape. The results of
applying the EDM method, which enables the production of microparticles while maintaining
size, sphericity, and distribution, demonstrate the efficiency and broad applicability of the
powder in additive manufacturing technologies.

Published

2026-02-18

How to Cite

Гоипов, Б., Тулаганов, С., & Зарипов, А. (2026). Production of Ti-6Al-4V microparticles by electrolyte discharges. “Uzbek Journal of Physics”, 27(4). https://doi.org/10.52304/.v27i4.619

Issue

Section

03. Physical Electronics. Physical Kinetics and Plasma Physics

Most read articles by the same author(s)